SYSTEM INTEGRATION

From test requirements to a working system.

Bring the fixture, instrumentation and software together around your device under test. Use these four steps to structure your integration project.

Connecting cables to Testblox modules mounted inside a test fixture.
Connecting cables to Testblox modules mounted inside a test fixture.

  1. Define the test requirements

    Start with the device under test: the signals to source, switch, measure and communicate. Record limits, timing, throughput and traceability requirements.

  2. Design the fixture and connections

    Choose a mechanical layout and a pin-to-pin or wired interface. Consider signal paths, access for service and how the DUT is connected.

  3. Select instrumentation and software

    Map each test requirement to the required modules and interfaces. Plan how Brygga, ASCII commands or programming APIs fit into the development workflow.

  4. Validate, document and maintain

    Verify the complete test sequence against the requirements. Document configuration, wiring and software so the system can be serviced and replicated.